Purchase your copy of ASTM C – 88() as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. Designation: C − 88 (Reapproved ) Standard Test Method for For referenced ASTM standards, visit the ASTM website, , or. Find the most up-to-date version of ASTM C at Engineering

Author: Vobei Meztihn
Country: Barbados
Language: English (Spanish)
Genre: Health and Food
Published (Last): 19 March 2013
Pages: 26
PDF File Size: 13.66 Mb
ePub File Size: 20.77 Mb
ISBN: 470-1-93240-852-6
Downloads: 9777
Price: Free* [*Free Regsitration Required]
Uploader: JoJoktilar

These faces shall be perpendicular.

ASTM International – Laboratory Directory – University of Dayton Research Institute

Significance and Use 3. A superscript epsilon e indicates an editorial change since the last revision or reapproval. The wstm of all specimens shall be ground or lapped to yield plane and parallel faces. Discard any pieces exhibiting cracks or flaws visible to the unaided eye.

Originally published as C — 74 to replace C and C The spherical surfaces shall be well lubricated, and the center of curvature shall lie on the lower face of the platen. Precision and Bias 8. The compo- nents of variance for compressive strength results v773 as coefficients of variation were calculated as follows: Single-operator component Between-laboratory component 1. Place an appropriate guard around the specimen to contain flying fragments at failure; eye protection should be used by the operator.


Enviado por Thamyres flag Denunciar.

One operator in each laboratory tested ten specimens of each material. This test is a measure of the potential load-bearing usefulness of a ceramic. New cushion pads shall be used for each specimen. A number in parentheses indicates v773 year of last reapproval. If the contact block is cracked during testing, it shall be replaced.

It is the responsibility of the user of this standard to establish appro- priate safety and health practices and axtm the applica- bility of regulatory limitations prior to use. C — 88 Reapproved Standard Test Method for Compressive Crushing Strength of Fired Whiteware Materials1 This standard is issued under the fixed designation C ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.

ASTM C773 – 88(2016)

Ideally, ceramics should be stressed this way in use. Current edition approved Sept. They may be formed and matured for the purpose of compression testing, or they may be cut from matured whitew- are by sawing or coredrilling.


C 5 compressive strength of the specimen, psi or MPa; P 5 total load on the specimen at failure, lbf or N; and A 5 calculated area of the bearing surface of the specimen, in. Suitable materials for cushion pads, selected in accordance with the compressive strength range of the material being tested, are shown in the following table: Last previous edition C — 88 NOTE 1—It is desirable to include details of the origin of the specimen and subsequent treatment.